Tuesday, September 25, 2012


PIC18F46K20 MCU CRACK,microchip chip decrypt, chip code

extraction, pic chip crack, pic chip clone, microchip chip

products clone.PCB cLone.

High Performance RISC CPU:
C Compiler Optimized Architecture:- Optional extended

instruction set designed tooptimize re-entrant code
Up to 1024 bytes Data EEPROM
Up to 64 Kbytes Linear program memoryaddressing
Up to 3936 bytes Linear data memory addressing
Up to 16 MIPS operation
16-bit wide instructions, 8-bit wide data path
Priority levels for interrupts
31-level, software accessible hardware stack
8 x 8 single-cycle hardware multiplierFlexible Oscillator

Precision 16 MHz internal oscillator block:- Factory calibrated

to ± 1%- Software selectable frequencies range of31 kHz to 16

MHz- 64 MHz performance available using PLL –no external

components required
Four crystal modes up to 64 MHz
Two external clock modes up to 64 MHz
4X Phase Lock Loop (PLL)
Secondary oscillator using Timer1 @ 32 kHz
Fail-Safe Clock Monitor:- Allows for safe shutdown if peripheral

clockstops- Two-Speed Oscillator Start-upSpecial Microcontroller

Operating Voltage Range: 1.8V to 3.6V
Self-Programmable under Software Control
Programmable 16-Level High/Low-VoltageDetection (HLVD) module:-

Interrupt on High/Low-Voltage Detection
Programmable Brown-out Reset (BOR):- With software enable option
Extended Watchdog Timer (WDT):- Programmable period from 4 ms to

Single-Supply 3V In-Circuit SerialProgramming™ (ICSP™) via two

In-Circuit Debug (ICD) via Two PinsExtreme Low-Power

Managementwith nanoWatt XLP™:
Sleep mode: 100 nA
Watchdog Timer: 500 nA
Timer1 Oscillator: 500 nA @ 32 kHzAnalog Features:
Analog-to-Digital Converter (ADC) module :- 10-bit resolution,

13 External Channels- Auto-acquisition capability- Conversion

available during Sleep- 1.2V Fixed Voltage Reference (FVR)

channel- Independent input multiplexing
Analog Comparator module:- Two rail-to-rail analog comparators-

Independent input multiplexing
Voltage Reference (CVREF) module- Programmable (% VDD), 16

steps- Two 16-level voltage ranges using VREF pinsPeripheral

Up to 35 I/O pins plus 1 input-only pin:- High-Current

Sink/Source 25 mA/25 mA- Three programmable external interrupts-

Four programmable interrupt-on-change- Eight programmable weak

pull-ups- Programmable slew rate
Capture/Compare/PWM (CCP) module
Enhanced CCP (ECCP) module:- One, two or four PWM outputs-

Selectable polarity- Programmable dead time- Auto-Shutdown and

Master Synchronous Serial Port (MSSP) module- 3-wire SPI

(supports all 4 modes)- I2C™ Master and Slave modes with

Enhanced Universal Synchronous AsynchronousReceiver Transmitter

(EUSART) module:- Supports RS-485, RS-232 and LIN- RS-232

operation using internal oscillator- Auto-Wake-up on Break-

Auto-Baud Detect

1 comment: